COOL BLASTER® HIGH PRESSURE COOLANT SYSTEMS

Direct high-pressure coolant increases tool life and improves finishes

  • Exceptional tool for performing deep hole operations such as gun-drilling and boring. Properly applied, high-pressure coolant is an effective solution for all chip control problems.

  • Cycle time for drilling can be reduced 40–70% with direct high-pressure coolant. The material is less likely to work harder, making drilling easier and in many cases eliminating the need for peck drilling cycles!

    • High-speed Drilling Operations

    • Chip Control For Turning And Grooving Improved Surface Finish

    • Increased Tool Life

    • Reduced Cycle Time

    • Greater Throughput

5 Line System

  • Model CB105V

    • Coolant is continuously filtered through 5 micron filter

    • Independent feed pump improves filter bag life

    • 5 high pressure coolant lines

    • Washable air inlet filter

    • Space saving vertical design

5 & 10 Line Systems with Heat Exchanger

  • Model CB510 Available in Horizontal & Vertical Designs:

    • Coolant moves through 5 micron filter and heat exchanger providing filtration and heat removal even when the high pressure system is not in operation reducing operating temperature of the coolant.

  • Features:

    • Independent feed pump standard

    • 2,000 CFM heat exchange system standard

    • Vertical or horizontal design

    • Available in 5 and 10 line systems

Specifications:

  • 2,000 PSI, 6.5 GPM

  • 7.5 HP

  • 5 micron filtration

  • Heat exchange system

  • PLC control integration

  • Electrical interface harness

  • Installation kit (HP hoses, fittings, manifold blocks for coolant distribution)

  • Diagnostic indicator lights

  • Restricted filter automatic shut off

  • Voltage: 200/230V 40.0 full load amps (optional 440/480V 30.0 full load amps)

Dual Filter High Pressure Coolant System

  • Model CB610V 10 Line System with Heat Exchanger:

    • The CB610 dual filter system is designed to automatically change-over to the secondary filter when the primary filter becomes clogged. The filter change-over will not stop production, therefore unattended or third shift operations can continue without disruption.

  • Features:

    • No loss of production to change clogged filter

    • Automatic change over from clogged filter to clean filter

    • System removes excess heat from coolant during operation

    • Independent feed pump improves filter bag life

    • Air purge system automatically removes coolant from clogged filter canister

    • Washable air inlet filter provides clean air flow for heat exhange system

    • Space saving vertical design: 19.5” x 51.4” x 43.4”

Specifications:

  • 2,000 PSI, 6.5 GPM

  • 7.5 HP

  • 5 micron filtration

  • Heat exchange system

  • PLC control integration

  • Electrical interface harness

  • 10 high pressure coolant lines

  • Installation kit (HP hoses, fittings, manifold blocks for coolant distribution)

  • Diagnostic indicator lights

  • Voltage: 200/230V 40.0 full load amps (optional 440/480V 30.0 full load amps)